A continuous casting machine consists of several equipment units that work together to convert molten steel into solid cast products. Its main components include the tundish, mold, mold oscillation mechanism, dummy bar, secondary cooling zone, withdrawal and straightening unit, and cutting machine.
Each component performs a specific task in the casting process, including molten steel distribution, initial solidification, strand withdrawal, secondary cooling, straightening, and cutting to length.
Tundish
The tundish is an intermediate vessel between the ladle and the mold. It receives, temporarily holds, and distributes molten steel, ensuring a stable and continuous supply to the mold.
Molten steel flows from the ladle into the tundish and then enters the mold through devices such as submerged entry nozzles. The tundish also provides a buffer during ladle changes and helps regulate the flow rate and direction of the molten steel, maintaining continuity during casting.
Mold
The mold is the main component responsible for the initial cooling and solidification of molten steel. As the steel enters the mold, heat is extracted through the mold cooling system, forming an initial solidified shell along the mold wall.
The mold cross-section determines the basic cross-sectional dimensions of the cast strand. Its design, cooling conditions, and operating state all affect the forming quality of the casting.
Mold oscillation mechanism
The mold oscillation mechanism works together with the mold, producing periodic vertical movements at a specified stroke and frequency.
During continuous casting, the initial solidified shell may stick to the mold wall. Mold oscillation improves lubrication between the shell and the mold, reduces friction and sticking, and allows the strand to move through the mold more smoothly. Oscillation parameters also affect strand surface quality.
Dummy bar
The dummy bar is mainly used during the start-up of continuous casting. Before casting begins, its head is positioned at the bottom of the mold to temporarily close the mold outlet. This allows the initial molten steel to solidify and connect to the dummy bar.
Once casting starts, the dummy bar pulls the initial solidified strand downward and draws it out of the mold into the downstream secondary cooling and withdrawal sections. After normal continuous casting is established, the dummy bar is disconnected from the strand and retrieved for the next casting operation.
Secondary cooling zone
When the strand leaves the mold, its surface has formed a solidified shell, but liquid steel usually remains inside. The secondary cooling zone further cools the strand using water sprays or a mixture of water and air. This process gradually solidifies the remaining liquid core.
The zone is generally equipped with support and guide rolls. These rolls support and contain the strand during cooling, limiting excessive deformation caused by ferrostatic pressure and keeping the strand on its designated path.
Secondary cooling conditions affect the solidification process and internal quality of the cast product.
Withdrawal and straightening unit
The withdrawal and straightening unit pulls the strand through the continuous casting machine and performs bending or straightening where required by the caster design. It generally consists of multiple driven rolls and associated mechanical drive components. The rolls grip the strand and provide the traction needed for continuous movement.
In curved casters, this unit also gradually straightens the strand as it moves from the curved section toward the horizontal discharge section.
Withdrawal speed and roll gap settings must match the pouring rate and solidification condition of the strand to maintain stable casting operation.
Cutting machine
The cutting machine divides the continuously moving strand into specified lengths for subsequent rolling, processing, and transportation.
Depending on the caster configuration and production requirements, cutting equipment may use flame cutting or mechanical shearing. The cutting system must remain synchronized with strand movement to maintain the required cutting length and avoid interrupting production.
Custom machining of components for continuous casting equipment
The manufacture and maintenance of continuous casting machines involve various mechanical and transmission components, including roller shafts, bearing housings, connecting parts, and mounting supports.
For non-standard components with specific dimensional or structural requirements, we provide precision machining based on customer-supplied drawings. Both single-piece and small-batch orders are supported.
Hansheng Automation machines shafts, transmission components, and other non-standard mechanical parts according to equipment drawings and design requirements.
Our precision machining services also cover other industries, including structural components for yacht equipment, precision parts for RC racing cars, tobacco packaging machinery components, and parts for filling machinery. We manufacture these components according to customer drawings for different equipment applications.


