On October 28, the 800,000 tons/year full-density polyethylene unit of the second chemical department of Guangdong Petrochemical Company successfully converted to HPR-1018HA seed material for the first time for 5 days, and has produced 5,000 tons of metallocene polyethylene products. At present, the production of the device is stable and the product quality is good. Wang Kai, a process engineer of the company's second chemical department, said that the reason why they were able to successfully switch production and have good product quality is due to their innovative "wall-climbing robot".

Wall-climbing robots
It is understood that the "wall-climbing robot" can be fully detected, swept and prevented. It not only shortens the original 8-hour purging time to 3 hours, but also makes the expanded section of the reactor clean, especially the dust on the top of the reactor dome is blown so that "no flakes are left", which provides a strong guarantee for the smooth start-up and production of the full-density polyethylene plant and the quality of metallocene catalyst products.
The robot is equipped with three powerful purge ports and a multi-angle camera to visually observe the dust accumulation in the reactor. Through the action of the strong magnet at the bottom, it can be directly adsorbed on the wall of the reactor and move freely in the reactor, with a wide purging range and a much cleaner degree than before. Wang Kai said.
According to reports, the reactor is an important equipment of the full-density polyethylene plant, the expansion section of the reactor is not clean, and the polyethylene powder will form flakes due to poor scouring, and once it falls off to the reactor, the fluidization state is not good, causing production fluctuations. "The maximum diameter of the reactor expansion section is nearly 10 meters, and the cleaning area is 256.3 cubic meters. Wang Kai introduced.
In order to further improve the maintenance efficiency, the company's second chemical department innovated ideas and thinking, empowered the maintenance work of the device with the application of science and technology, and cooperated with robot manufacturers to develop the first intelligent "wall-climbing robot" for many times.
Wang Kai introduced that after using the "wall-climbing robot" for the first time, they found two biggest changes, one is that there is no residue of polyethylene powder in the reactor dome, which is helpful to the quality of metallocene film, and the crystal point of the newly produced polyethylene product after blowing the film is significantly reduced compared with the previous start-up stage; Second, the metallocene catalyst used in this conversion has extremely high requirements for the level control of the reactor expansion section, and the fluidization state was not found to be affected by the flake falling off during this cleaning.
"Since the start of the plant, we have deepened technological innovation, actively implanted new innovative means and concepts, and carried out re-innovation through introduction, digestion and absorption, taking the initiative, and continuing to make efforts to continue to provide high-quality and efficient chemical products for the market." Yu Xianjian, executive deputy manager of the company's second chemical department, said.
