Why does the positioning accuracy of the cam divider decrease?

May 28, 2025 Leave a message

The positioning accuracy of the cam divider may decrease due to a variety of factors. The following are common reasons and detailed analysis:

 

1. Mechanical wear

 

Cam and roller wear: After long-term operation, the wear of the cam profile or roller surface will cause the contact gap to increase, and return error or shaking will occur during transmission.

 

Bearing wear: After the bearing supporting the divider turntable is worn, the radial or axial clearance increases, which directly affects the positioning stability.

 

Solution: Check the wear condition regularly, replace high hardness/wear-resistant materials (such as carburized steel rollers), or use lubrication measures to reduce wear.

 

2. Assembly error

 

Concentricity/parallelism deviation: The input shaft (drive end) and the output shaft (load end) are not installed concentrically, or the coupling is poorly aligned, resulting in additional stress or vibration.

 

Loose fasteners: Insufficient bolt preload may cause structural micro-motion and cumulative errors.

 

Solution: Use a laser alignment instrument for calibration and check the fastener torque regularly.

 

3. Poor lubrication

 

Lubricant failure: Grease drying or contamination will increase friction and cause uneven movement.

 

Improper lubrication method: For example, high-temperature resistant grease should be selected under high-speed conditions.

 

Solution: Replace lubricants periodically as required by the manual, and use synthetic grease for high-temperature environments.

 

4. Load change

 

Inertia force influence: Excessive load inertia or sudden acceleration and deceleration may cause the cam and roller to instantly lose contact ("tooth jump").

 

Eccentric load problem: The center of gravity of the load deviates from the axis of the divider, generating additional torque.

 

Solution: Recalculate the load inertia and increase the reduction ratio or balancing device if necessary.

20240802162326

5. Elastic deformation

 

Insufficient transmission chain stiffness: For example, when the synchronous belt is driven, the belt stretching will cause hysteresis error.

 

Structural deformation: Poor frame rigidity may amplify vibration.

 

Solution: Use direct drive (such as servo motor + coupling) or reinforce the frame.

 

6. Increased backlash

 

Gear/chain transmission pair wear: When driven indirectly, backlash accumulation will affect the output accuracy of the divider.

 

Solution: Replace the anti-backlash gear or use a preloaded structure.

 

7. Environmental factors

 

Temperature change: Thermal expansion and contraction of metals may change the clearance of key components.

 

Pollution: Dust and chips invade the cam groove and interfere with the movement of the roller.

 

Solution: Add a protective cover or use stainless steel to resist corrosion.

 

8. Improper design or selection

 

The number of divider stations does not match the accuracy: For example, a coarse indexing model is selected for high-precision scenarios (such as 8 stations is better than 6 stations).

 

Insufficient dynamic accuracy: The acceleration impact during start-stop was not considered during selection.

 

Solution: Reselect to ensure that the static accuracy (such as ±30 arcsec) and dynamic performance meet the standards.