What situations will planetary servo reducers present during the running in period

Nov 05, 2024 Leave a message

Firstly, due to the influence of factors such as the installation and debugging of new reducer components, the contact area of the cooperative surface is small and the promised torque is large in the rapid wear rate of planetary reducers. During the operation of the reducer, the concave and convex parts on the surface of the parts collide with each other, and the grinding metal waste as abrasive continues to participate in the collision, accelerating the wear of the cooperative surface. spare parts. Therefore, during the running in period, simple wear of parts (especially matching surfaces) is caused, and the wear rate is too fast. At this moment, if overloaded, it may cause component damage and lead to early defects.


The second point is that parts that are loosely processed and assembled have certain matching standards. In the initial stage of application, they are affected by replacement loads, such as? Vibration and? Deformation and excessive wear. The reason is simply to loosen the originally fixed components.

 

GPB042-L142


Thirdly, poor lubrication is due to the small cooperation gap of newly assembled parts, and due to device and other reasons, lubricating oil (fat) is not easy to form a uniform oil film on the contact surface to avoid wear. As a result, the lubrication power is reduced, leading to abnormal wear of the machine in the early stage. In severe situations, the resistance surface of precision collaboration may be scratched or bitten, leading to defects.


Fourth point: Many operational errors are caused by the gearbox? The lack of understanding of the structure, especially among new operators, can easily lead to defects due to operational errors, and even result in mechanical and safety incidents.


Fifth point: Due to parts? Vibration and loosening of the reducer heat exchanger can cause leakage, and the sealing surfaces of the reducer and pipe joints may also leak; It is difficult to find defects such as casting during assembly and debugging, but due to vibration during operation? Defects are exposed and oil leaks (seeps) appear. Therefore, leaks may sometimes occur during the break in period.