What are the ways to improve PVD coating large particles?

May 05, 2025 Leave a message

The physical stacking gas phase method is the mainstream method for the preparation of PVD coatings, including vacuum coating, magnetron sputtering and arc ion plating, among which, when ion plating is used to prepare PVD coatings, the ionization rate is high, the accumulation rate is fast, and it has the advantages of large incident ion energy, high film-based bonding, and good coating quality. However, this PVD coating has large particle pollution, which leads to problems such as rough coating appearance, porosity addition, and unstable coating function, which affects the use of customers. Here's how to improve PVD coating with large particles.

PVD Coating

1. The introduction of rare earth elements

The introduction of rare elements in cathode targets and PVD coatings to reduce ion plating particles and improve the fine density of coatings, and to improve the physical and mechanical properties and high-temperature properties of the coatings through the rare earth modification mechanism, the effect is obvious. Rare earth Ce has an obvious effect on reducing droplets, and the PVD coating modified by rare earth not only has a small droplet density, but also has fewer large droplets. The reason for the improvement of the coating particle condition of rare earth Ce should be directly related to the metallurgical quality of rare earth progress targets.


Rare earth elements Widely utilized are Ce's metallurgical process for degassing, desulfurizing, and toughening of metal materials qualities. The metallurgical quality and functionality of the material may be raised by introducing the suitable dilute element Ce to the goal. Few pores, homogeneous composition, and fine grains of the high-quality target material help to refine the particles produced from the cathode. It may lower the possibility of material fragmentation and splashing in the cathode arc spot micromelt pool region resulting from the high pressure produced by the abrupt expansion of the gas in the closed pores at high temperature. By avoiding or mitigating the collapse and flyaway of weakly bonded materials resulting from partial electric fields or thermoelastic stress, the target arrangement may help to lower the generation of big particles. Apart from Ce, rare earth elements like Y or La have comparable influence.

 

2. The new electromagnetic system

This skill was considered from the design of improved cathode targets and plasma optics. The idea is to design a new magnetic field structure inside and outside the target, including a special electromagnetic coil and a permanent magnet with a specific structure, so that it forms an arched magnetic field system on the cathode target, so as to control and regulate the running track of the cathode arc spot, accelerate its motion speed, and reduce the residence time of the arc spot at a certain point on the target surface.

 

3. Add a baffle to the device

The analysis reveals that the predominant distribution of the big particles is in the region at an angle of 60° to the surface of the arc target; so, a baffle may be placed in front of the arc target to lower the large particle film layer's pollution level. While the size of big particles was smaller than 2 μm, the density of large particles dropped from 2.3 x 105/mm2 to 1.4 x 103/mm2 without baffle did not change substantially. But once the baffle is put in place, the PVD coating's purpose suffers in addition to lowering the accumulation rate.

 

4. Hollow cathode skills

In the arc ion plating stacking PVD coating, the electron beam emitted by the hollow cathode is introduced to reduce the large particle size of the prepared coating, but this method requires the addition of a hollow cathode device in the conventional ion plating equipment.

 

5. Arc magnetic filter

The method of introducing the plasma into the accumulation chamber by using the arc magnetic filter to separate the large particles from the plasma has achieved a good effect, but the accumulation rate of this method is much lower than that of ordinary arc ion plating.


The above is the introduction of the method of improving the large particles of PVD coating, in the preparation of PVD coating, you can refer to the above five methods to ensure that the coating surface structure is fine, the porosity is low, and the properties are stable, so that the use effect of the coating will be better.