Components
Car body, output shaft, output shaft oil seal, output bearing, sun nut, planetary frame, inner gear ring, planetary gear, stage gear, needle shaft, sun gear, C-type snap ring, force bearing, loading shaft oil seal, force flange, O-ring, breathable plug, key, gasket, internal hexagonal screw, etc.
Transmission concepts
Sun gear, Planetary gear along with planetary frame, Inner gear ring, Stage instruments
Direct activation of the solar gear by the driving source will unite with the planetary gear on the planetary gear frame to drive the operation. The planetary frame links the output of the output shaft to get acceleration; the whole planetary gear system runs automatically along the outer gear ring. Higher deceleration rates call for the numerous set of planetary gears and stage gear multiplication.

Characteristic of deceleration
The planetary gear's mechanism is the same as the conventional parallel gear's transmission approach and high torque and impact resistance. Pressure alone from the contact surface of two gears drives the conventional gear deceleration. Many gear surfaces, however, carry all the loads, which makes gear fracture rather simple. The planetary reducer has a 360-degree load on its contact surface. It allows high intensity functioning free from harm.
Traditional gears often create friction and breakage since all the load is concentrated on the few gear surfaces that interact with each other and depend just on a very small amount of contact surface between the two gears to be pushed by pressure. equipment. Whereas the bearing components do not survive higher torque and the impact of the body, the planetary gear reducer has a 360-degree uniform load on the 360-degree contact surface of the gear and numerous gear surfaces uniformly bear the instantaneous impact load, so allowing it to endure. Big loads will cause damage to it.

The conventional gear reducer is made using several sets of big and tiny gears to staggered transmission, and light weight. The space of the gearbox is vast since the reduction ratio must be produced by the multiple of the two gears. This is especially true when the high speed ratio is combined since it calls for more than two gears. The gearbox's connection combination creates a great loss of volume and weight, somewhat lowers structural strength, and stretches its length. The multi-section combination can be finished independently and the construction of the planetary reducer can be repeatedly joined depending on the necessary number of sections.
