Planetary gearbox installation method and steps

Aug 20, 2024 Leave a message

Among the reducer products, planetary gearboxes are widely used in servo, stepper, DC and other transmission systems due to their small size, high transmission efficiency, wide deceleration range and high precision. Its function is to ensure the premise of precision transmission, it is mainly used to reduce the speed, increase the torque and reduce the load/motor moment of inertia ratio. In the past few years, some users in the use of reducer, due to human factors such as installation, resulting in the reducer output shaft broken, so that the enterprise suffered unnecessary losses. Therefore, in order to better help the majority of users to use the reducer, we will introduce to you in detail how to install the planetary gearbox correctly.

 

Correct installation, use and maintenance of the reducer is an important part of ensuring the normal operation of mechanical equipment. Therefore, when installing the planetary gearbox, please be sure to strictly follow the following installation and use related matters, and carefully assemble and use.

 

1. Before installation, confirm whether the motor and reducer are intact, and strictly check whether the dimensions of each part connected to the motor and the reducer match, here are the dimensions and matching tolerances of the positioning boss, input shaft and reducer groove of the motor.

 

2. Unscrew the screws on the dustproof hole on the outside of the flange of the reducer, adjust the clamping ring of the PCS system to align the side hole with the dustproof hole, insert the hexagon and tighten it. After that, remove the motor shaft key.

 

3. Connect the motor with the reducer naturally. When connecting, it is necessary to ensure that the concentricity of the output shaft of the reducer and the input shaft of the motor is consistent, and the outer flanges of the two are parallel. If the misalignment is inconsistent, it will cause the motor shaft to break or the reducer gear to wear.

 

In addition, it is strictly forbidden to hit with a hammer during installation to prevent excessive axial or radial force from damaging the bearings or gears. Be sure to tighten the mounting bolts before tightening the force bolts. Wipe the anti-rust oil on the motor input shaft, positioning boss and reducer connection with gasoline or zinc sodium water. The aim is to ensure tightness and flexibility of the connection and to prevent unnecessary wear and tear.

 

Before the motor is connected to the reducer, the motor shaft keyway should be perpendicular to the tightening bolt. In order to ensure that the force is uniform, first screw the mounting bolts in any diagonal position, but do not tighten them, then screw on the other two installation bolts in diagonal positions, and finally tighten the four mounting bolts one by one. Finally, tighten the force bolt. All tightening bolts need to be fixed and checked with a torque wrench according to the indicated fixed torque data.

 

The correct installation between the reducer and the mechanical equipment is similar to the correct installation between the reducer and the drive motor. The key is to ensure that the concentricity of the output shaft of the reducer is consistent with the shaft of the driven part.

 

info-450-350