Some indexers are designed with axial force only at one end of the camshaft, so it is stipulated that it cannot be reversed when working with load.But often the initial commissioning, in order to detect the electromechanical steering occasional reversal of the situation, in order to be on the safe side, the indexing disk on the best first not connected to the load, to be detected and then connected to the load.
Electromechanical general and worm gear accelerator connected to the output shaft of the dismemberment rigid connection, electromechanical and reducer may be rigidly coupled with synchronous belt adjacent, do not advocate the use of triangular belt adjacent. Thinking about the topic of indexing disk overload, the placement of torque limiter is reasonable.
Indexer, reducer and electromechanical drive end configuration. Because of the different motion curves have a gap between the maximum slowdown and the maximum rate of value, so there is a gap between the drive configuration, indexing manufacturers need to calculate and configure the drive end for the user to configure.
The output axis has to turn 360 degrees, the indexing disk to turn a station; also have to turn 180 degrees, the indexing disk to turn a station. If your hour is 3600 degrees of the situation, it is necessary to think about frequency control, admittedly, may also use two-speed electromechanical, frequency control is to be equipped with a frequency converter. Because the electric Omni turn a lot of turns dismemberer only to turn a circle, and the indexer has a static angle, when the stop, because the impact of the load yinny electromechanical will be faster stop, so without brakes is possible, if the plea for fast stop, the choice of electromechanical with a car is the ideal resolution.